COPYRIGHT © 2004 MERIT INDUSTRIES, INC.
ATTENTION:
OBSERVE PRECAUTIONS FOR HANDLING ELECTROSTATIC DEVICES
Removal/Installation of Touchscreen -
FORCE Radion Countertop/Fun Zone JR.
Troubleshooting Information - Removal/Installation of Touchscreen -
FORCE Radion Countertop/Fun Zone JR.
Megatouch FORCE Technical Reference Manual
Touchscreen Removal
1. Turn off and unplug the game.
2. Unlock and open/remove the rear door and the side doors.
3. Remove the cash box.
4. Remove the screw securing the strain relief cord to the rear door, then remove the monitor
board from the velcro on the rear door.
5. Remove the screws holding the rear bezel to the game. Five screws are located along the top
edge of the game and 2 are at the bottom rear of each side of the game. See Figure 1.
6. Lift the rear bezel from the game.
7. Remove the 4 screws holding the front bezel to the game. Two screws are located at the
bottom on each side of the game (see Figure 1) and 2 are on the top surface (see Figure 2).
8. Lift the front bezel from the game.
9. Remove the two nuts and washers securing the touchscreen controller (see Figure 3) to the
game and remove the controller from the mounting screws. Then disconnect the cable from
the back of the controller and disconnect the Molex connector (orange and gray wires) running
from the touchscreen controller cable to the main power harness.
10. Remove the black poly tape from around the edges of the old touchscreen. Remember how
the tape was placed in order to tape the new touchscreen.
11. Use dental floss to carefully cut the foam tape holding the touchscreen to the picture tube until
you are able to completely remove the touchscreen.
12. Remove any remaining adhesive residue with denatured alcohol, then wipe the surface of the
picture tube with the supplied alcohol wipe.
Touchscreen Installation
1. Clean the reverse side of the replacement touchscreen with the supplied alcohol wipe.
2. Peel the backing from the 8 pieces of foam tape already adhered to the reverse side of the
touchscreen. Then cut 8 pieces of equal size from the supplied roll of 3/8” double-sided foam
tape (the thinner of the two supplied 3/8” rolls) and place them (backing side facing out) on the
tape already on the touchscreen before peeling off the backing. The double-thickness of the
foam tape will allow enough distance between the touchscreen and the picture tube once the
new screen is in place.
3. Replace the new touchscreen over the picture tube (with the cable on the left if you are facing
the game), making sure the screen is properly and evenly aligned over the picture tube. Then
clean the front of the screen with the supplied alcohol wipe.
4. Connect the new touchscreen controller cable in the back of the controller (see Figure 3) and
secure the controller on the mounting screws in the game with the existing hardware. Also
connect the Molex connector (orange and gray wires) to the main power harness.